When we usually use a automatic horizontal baling press machine, we need to pay attention to the maintenance and care of the baler. This will extend the service life of the baler. So, how do you clean and maintain a automatic horizontal baling press machine?
Preparations for Automatic Horizontal Baling Press Machine Maintenance
Before cleaning and maintaining the automatic horizontal baling press machine, please turn off the main power (rotate the main power switch to OFF), and wait for about 5 minutes for the hot knife temperature to drop, then proceed with the maintenance and repair of the baler.
Cleaning the Automatic Horizontal Baling Press Machine
How to ensure high reliability, durability, and service life of the automatic horizontal baling press machine mainly depends on regular cleaning and maintenance of the machine. Also, the strap feeding wheels, the strap press wheels, and the tension wheels need to be kept away from lubricants and grease.
Maintenance of the Automatic Horizontal Baling Press Machine
Daily Maintenance
After using the automatic horizontal baling press machine every day, pay attention to its maintenance. Use an air gun to daily clean the reciprocating moving parts in the machine core, such as the knife holder part, strap feeding wheel part, and tension wheel part. Also, remove any other residues left on the machine.
Weekly Maintenance
Apply lubricant to the three knives (front knife, middle knife, rear knife) in the knife holder and the positioning pins of the bow frame bearing seat. Before applying lubricant, ensure that the lubricant you use does not contain residues, and also remove any residues from the parts.
Monthly Maintenance
If necessary, use sandpaper to remove the residues on both sides of the hot knife heating head surface of the automatic horizontal baling press machine, but note that the surface temperature of the hot knife heating head must have cooled down in advance. Also, inspect the hot knife assembly to ensure that, under the action of the spring force, the hot knife heating head can easily return to its position. Additionally, remove the residues adhered to the surface of the tension wheel.
Semi-annual Maintenance
Inspect the automatic horizontal baling press machine hot knife surface, and replace or adjust the hot knife if necessary.
Inspect the middle knife, and replace it if necessary.
Inspect the wire harness on the circuit board to see if it is loose, and reconfirm and fasten the wire harness.
Inspect the automatic horizontal baling press machine front panel cover and right side door safety switches to ensure they work properly; check if the machine is working normally.
If necessary, replace the automatic strap feed wheels, adjust the automatic strap feed force, the gap inside the brake of the strap reel, and apply a small amount of lubricant to the support points of the hot knife assembly.
Annual Maintenance
Inspect the automatic horizontal baling press machine machine itself, and replace any misaligned or worn wheels you can see. Replace the bearings if they make squeaking noises. Perform several normal packaging operations while running the machine to check if it is working properly.
